Also, the minimum timer-cutoff value is 6 hours.Ĭan I connect my Power Magic Pro to another battery pack? The voltage-cutoff setting is always activated to prevent car battery drainage. Typical examples include fuse for the air-conditioning unit, radio, windows, etc.Ĭan I use only one cut-off setting at a time, deactivating the other? *A switched fuse is a fuse that is only activated when the car's engine is on. Some examples include fuse connections to the car's door lock, horn, airbags, etc. *A constant fuse is a fuse that remains active all the time, even if the car's engine is off. *The other two wires (black and red) are connected to a female socket where the cigarette power cable of the camera should be plugged. The Black wire is the GND (ground) wire that should be connected to any bare, unpainted, metal part, usually to a bolt near the fuse box, for grounding. The Red wire is the ACC+ that should be connected to an "switched" fuse. The Yellow wire is the BATT+ wire that should be connected to a "constant" fuse. *The Power Magic Pro has three wires that should be connected to the car's fuse panel. What are the wires of the Power Magic Pro? Rather, it is a device that is connected directly (hardwiring) to the car's fuse panel and supply power to the camera depending on the cut-off settings to prevent battery drain. *Power Magic Pro is not a battery that provides power to the camera when the car's engine is off. Power Cut-off Settings: The Power Magic Pro will power your dashcam in parking mode until either your car battery voltage drops to the configured value or the configures timer elapses (whichever occurs first). Regardless of whether the switch is ON or OFF, the Power Magic Pro detects when you start your engine and automatically powers your dashcam while driving
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |